Adds a LEDManager class (src/helpers/ui/LEDManager.h) that centralizes
all LED control into one component with begin()/loop() lifecycle and
per-pin active-HIGH/LOW polarity support.
LED settings are exposed as custom vars (led.status, led.activity)
accessible via companion radio binary protocol, CLI set/get commands,
and the SensorManager settings interface.
Status LED modes: off, boot-30s, slow blink (200ms/4s), always on.
Activity LED modes: off, BLE only, LoRa TX only, BLE + LoRa TX.
Integrated into 23 board variants, replacing scattered hardcoded
digitalWrite calls in onBeforeTransmit/onAfterTransmit/powerOff.
As all NRF52 boards now have OTA support, let's remove the subclass
and integrate it into the base class.
Signed-off-by: Frieder Schrempf <frieder@fris.de>
The schematic shows the LC circuit for the internal DC/DC regulator
to be available. Enable it to save power.
Signed-off-by: Frieder Schrempf <frieder@fris.de>
The startOTAUpdate() is the same for all NRF52 boards. Use a common
implementation for all boards that currently have a specific
implementation.
The following boards currently have an empty startOTAUpdate() for
whatever reasons and therefore are not inheriting NRF52BoardOTA to
keep the same state: Nano G2 Ultra, Seeed SenseCAP T1000-E,
Wio WM1110.
Signed-off-by: Frieder Schrempf <frieder@fris.de>
Use a common begin() method that can be called from derived classes
to contain the shared initialization code.
Signed-off-by: Frieder Schrempf <frieder@fris.de>
