LoRa iGate & Digi software − Ricardo Guzman CA2RXU

Last 20 received packets list

Time*	Frame	RSSI	SNR

List refresh automatically every 15 seconds.
* - For now time is measured from board boot up.

Station

Add your Ham callsign and SSID.

You can leave a comment describing your station.

In the bottom there is a field for personal note that can only be seen in WEB GUI.

Callsign and SSID

Beacon Comment

Beacon path

Symbol

Latitude

Longitude

Personal Note

WiFi Access

Add all Wi-Fi Networks intended to be used.

APRS-IS

Enter you APRS-IS server and credentials.

Enable APRS-IS connection

Gate APRS-IS Messages to RF

Gate APRS-IS Objects to RF

Server

Port

Passcode

Filter

Beaconing

Set APRS beacon attributes.

Send our beacon to APRS-IS

Send beacon via RF

Interval

minutes

Digipeating

Define the Digipeater mode

Repeater Mode

LoRa

Config LoRa APRS Xmitting settings.

Enable LoRa TX

Enable LoRa RX

Tx Frequency

Rx Frequency

Predefined speeds

Bandwidth

Spreading Factor

Coding Rate

Power

dBm

Display

OLED screen configuration.

Always On

Turn 180º

Display Timeout

seconds

Remember Station Time

minutes

Battery

Battery Monitor & Health

Max Voltage on input pin is 3.3V.

Calculate voltage divider accordingly.

Send Internal Voltage

Monitor Internal Voltage Health

Internal Sleep Voltage

volts

Send External Voltage

Monitor External Voltage Health

External Sleep Voltage

volts

External Voltage Pin

External Voltage divider R1

kOhm

External Voltage divider R2

kOhm

Telemetry

Define Wx telemetry

Activate Wx Telemetry Requires a BME/BMP280, BME680 or Si7021 sensor installed

Height Correction (Above Sea-Level)

meters

Temperature Correction

C°

Syslog

Broadcast the system log over the network.

Enable syslog

Server

Port

TNC

TNC and KISS configuration

Server will be available at port 8001

Enable TNC server

Enable Serial KISS

Accept own frames via KISS

Reboot Time

Reboot Mode Active

Time before forced Reboot

hours

Auto AP

Add your password and power off timeout to auto access point. Auto AP will start if there is no WiFi connection. Timeout will count from startup or last client disconnected.

Password

Power off timeout (in minutes)

Set to 0 if you don't want this option.

OTA

Set your username and password to allow firmware updating over-the-air.

Username

Password

Admin

Set your username and password to allow access to the web interface.

Web interface authentication

Username

Password

Experimental

You can test new features. Use at your own risk!

When "only" iGate Mode loses WiFi, it will change into a Digirepeater Mode and after 15 min check if WiFi available and return to "only" iGate Mode.

Backup Digirepeater Mode

WiFi disabled. Sleep mode. Best for solar Digi with SX126X.

Low power mode (only for HT-CT62)

Low voltage cut off (Deep sleep below specific voltage) Volts

MCU will deep sleep when below provided battery voltage to save power. Set to 0 if you don't want this option. Please calibrate your voltage reading first!