This change fixes several lint errors throughout the project, and moves the SwiftLint build phase to before compilation.

After this change, a developer can now clone the project and run without the build failing due to lint errors! 😃

* I ran `swiftlint --fix` to resolve many auto-correctable issues (mostly whitespace)
* Excluded the `Meshtastic/Protobufs` directory from lint, since that code is automatically generated.
* Converted some single letter method parameters to lowercase.
* Converted several instances `force_cast` to instead use `guard` or `if let` to unwrap optional values. During this change, some of the SwiftUI views became "too complex to be solved in a reasonable time", so I broke up the views into distinct sub-expressions.

I was able to build and run the app on an iOS simulator.

Meshtastic/Views/Settings/Config/Module/DetectionSensorConfig.swift

@@ -44,9 +44,9 @@ struct DetectionSensorConfig: View {
 		VStack {
 			Form {
 				ConfigHeader(title: "Detection Sensor", config: \.detectionSensorConfig, node: node, onAppear: setDetectionSensorValues)
-				
+
 				Section(header: Text("options")) {
-					
+
 					Toggle(isOn: $enabled) {
 						Label("enabled", systemImage: "dot.radiowaves.right")
 						Text("Enables the detection sensor module, it needs to be enabled on both the node with the sensor, and any nodes that you want to receive detection sensor text messages or view the detection sensor log and chart.")
@@ -90,7 +90,7 @@ struct DetectionSensorConfig: View {
 								.autocapitalization(.none)
 								.disableAutocorrection(true)
 								.onChange(of: name, perform: { _ in
-									
+
 									let totalBytes = name.utf8.count
 									// Only mess with the value if it is too big
 									if totalBytes > 20 {
@@ -102,7 +102,7 @@ struct DetectionSensorConfig: View {
 						Text("Friendly name used to format message sent to mesh. Example: A name \"Motion\" would result in a message \"Motion detected\"")
 							.font(.callout)
 							.foregroundStyle(.gray)
-						
+
 						Picker("GPIO Pin to monitor", selection: $monitorPin) {
 							ForEach(0..<49) {
 								if $0 == 0 {
@@ -113,13 +113,13 @@ struct DetectionSensorConfig: View {
 							}
 						}
 						.pickerStyle(DefaultPickerStyle())
-						
+
 						Toggle(isOn: $detectionTriggeredHigh) {
 							Label("Detection trigger High", systemImage: "dial.high")
 							Text("Whether or not the GPIO pin state detection is triggered on HIGH (1) or LOW (0)")
 						}
 						.toggleStyle(SwitchToggleStyle(tint: .accentColor))
-						
+
 						Toggle(isOn: $usePullup) {
 							Label("Uses pullup resistor", systemImage: "arrow.up.to.line")
 							Text(" Whether or not use INPUT_PULLUP mode for GPIO pin. Only applicable if the board uses pull-up resistors on the pin")