mirror of
https://github.com/meshcore-dev/MeshCore.git
synced 2026-04-20 22:13:47 +00:00
e2aa33b3a0
Adds a LEDManager class (src/helpers/ui/LEDManager.h) that centralizes all LED control into one component with begin()/loop() lifecycle and per-pin active-HIGH/LOW polarity support. LED settings are exposed as custom vars (led.status, led.activity) accessible via companion radio binary protocol, CLI set/get commands, and the SensorManager settings interface. Status LED modes: off, boot-30s, slow blink (200ms/4s), always on. Activity LED modes: off, BLE only, LoRa TX only, BLE + LoRa TX. Integrated into 23 board variants, replacing scattered hardcoded digitalWrite calls in onBeforeTransmit/onAfterTransmit/powerOff.
36 lines
958 B
C++
36 lines
958 B
C++
#include "ThinkNodeM6Board.h"
|
|
#include <Arduino.h>
|
|
|
|
#ifdef THINKNODE_M6
|
|
|
|
#include <Wire.h>
|
|
|
|
void ThinkNodeM6Board::begin() {
|
|
NRF52Board::begin();
|
|
|
|
Wire.begin();
|
|
|
|
delay(10); // give sx1262 some time to power up
|
|
|
|
// Start LEDs with defaults; prefs are applied after loadPrefs()
|
|
static LEDManager _ledManager(PIN_LED_RED, PIN_LED_BLUE);
|
|
ledManager = &_ledManager;
|
|
ledManager->begin(LED_STATUS_BOOT_30S, LED_ACTIVITY_BOTH);
|
|
}
|
|
|
|
uint16_t ThinkNodeM6Board::getBattMilliVolts() {
|
|
int adcvalue = 0;
|
|
|
|
digitalWrite(PIN_ADC_CTRL, HIGH);
|
|
analogReference(AR_INTERNAL_3_0);
|
|
analogReadResolution(12);
|
|
delay(10);
|
|
|
|
// ADC range is 0..3000mV and resolution is 12-bit (0..4095)
|
|
adcvalue = analogRead(PIN_VBAT_READ);
|
|
digitalWrite(PIN_ADC_CTRL, LOW);
|
|
// Convert the raw value to compensated mv, taking the resistor-
|
|
// divider into account (providing the actual LIPO voltage)
|
|
return (uint16_t)((float)adcvalue * REAL_VBAT_MV_PER_LSB);
|
|
}
|
|
#endif
|