mirror of
https://github.com/meshcore-dev/MeshCore.git
synced 2026-04-20 22:13:47 +00:00
e2aa33b3a0
Adds a LEDManager class (src/helpers/ui/LEDManager.h) that centralizes all LED control into one component with begin()/loop() lifecycle and per-pin active-HIGH/LOW polarity support. LED settings are exposed as custom vars (led.status, led.activity) accessible via companion radio binary protocol, CLI set/get commands, and the SensorManager settings interface. Status LED modes: off, boot-30s, slow blink (200ms/4s), always on. Activity LED modes: off, BLE only, LoRa TX only, BLE + LoRa TX. Integrated into 23 board variants, replacing scattered hardcoded digitalWrite calls in onBeforeTransmit/onAfterTransmit/powerOff.
28 lines
No EOL
645 B
C++
28 lines
No EOL
645 B
C++
#include <Arduino.h>
|
|
#include <Wire.h>
|
|
|
|
#include "T1000eBoard.h"
|
|
|
|
void T1000eBoard::begin() {
|
|
NRF52BoardDCDC::begin();
|
|
btn_prev_state = HIGH;
|
|
|
|
#ifdef BUTTON_PIN
|
|
pinMode(BATTERY_PIN, INPUT);
|
|
pinMode(BUTTON_PIN, INPUT);
|
|
pinMode(LED_PIN, OUTPUT);
|
|
#endif
|
|
|
|
#if defined(PIN_BOARD_SDA) && defined(PIN_BOARD_SCL)
|
|
Wire.setPins(PIN_BOARD_SDA, PIN_BOARD_SCL);
|
|
#endif
|
|
|
|
Wire.begin();
|
|
|
|
delay(10); // give sx1262 some time to power up
|
|
|
|
// Start LEDs with defaults; prefs are applied after loadPrefs()
|
|
static LEDManager _ledManager(LED_GREEN, -1);
|
|
ledManager = &_ledManager;
|
|
ledManager->begin(LED_STATUS_BOOT_30S, LED_ACTIVITY_BOTH);
|
|
} |