Resolve conflicts: keep both Ethernet CLI and SenseCAP power-off
button code in repeater, keep both Ethernet docs and power management
CLI docs.
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
- Rename eth command to eth.status for consistency with other commands
- Rename generateDeviceMac to generateEthernetMac for clarity
- Refactor ethernet_handle_command to return false by default
- Allow new TCP clients to replace existing connections (repeater, room server, SerialEthernetInterface)
- Boot companion radio without Ethernet on init failure (LoRa-only recovery mode)
- Remove > prompt from ethernet CLI for consistency with serial interface
- Fix variable redeclaration compile error in SerialEthernetInterface when ETHERNET_STATIC_IP is defined
- Fix TCP socket leak when duplicate client detection fires
- Remove dead recv_queue and adv_restart_time members from SerialEthernetInterface
- Fix port numbers in docs (port 23 for repeater/room server CLI, port 5000 for companion radio)
- Clarify eth.status command is only available in repeater and room server firmware
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
The table of contents of `docs/faq.md` had at the end a bogous entry
```markdown
- [| | High Output | 22 dBm | 28 dBm | |](#--high-output--22-dbm--28-dbm--)
```
This patch removes that bogous entry.
Added to section 5.14 "Are there are projects built around MeshCore?":
* awesome-meshcore
* meshcore-open
* MeshCore-Cardputer-ADV
* LunarCore
* MC-Term
* Meck
* Meshcore for Wio Tracker L1 Pro
* MeshCore map auto uploader
Tested in v1.13.
These commands don't work anymore:
```
get password
-> ??: password
set password secret
-> unknown config: password secret
```
This does work:
```
password secret
-> password now: secret
```
- Trigger noise floor calibration every 2s and AGC reset every 30s in main loop.
- Reorder loop to match Dispatcher: calibrate + radio.loop() before AGC reset
and recvRaw() so RSSI is never sampled right after startReceive().
- Update protocol doc with calibration intervals and typical noise floor range.
- Variant platformio.ini updates (heltec_v3, rak4631).
Added NRF52840 power management core functionality:
- Boot‑voltage lockout
- Initial support for shutdown/reset reason storage and capture (via RESETREAS/GPREGRET2)
- LPCOMP wake (for voltage-driven shutdowns)
- VBUS wake (for voltage-driven shutdowns)
- Per-board shutdown handler for board-specific tasks
- Exposed CLI queries for power‑management status in CommonCLI.cpp
- Added documentation in docs/nrf52_power_management.md.
- Enabled power management support in Xiao nRF52840, RAK4631, Heltec T114 boards
Fix of a typo, change second sentence to start with a capital (like Q 3.6), adding missing dot in 3.8, and turn 3.8 into a question.
The file on dev branch is outdated, so submitting this on main.
