Tested in v1.13.
These commands don't work anymore:
```
get password
-> ??: password
set password secret
-> unknown config: password secret
```
This does work:
```
password secret
-> password now: secret
```
PacketQueue::add() silently dropped packets when the queue was at
capacity. The packet pointer was lost — never enqueued, never returned
to the unused pool. Each occurrence permanently shrank the 32-packet
pool until allocNew() returned NULL and the node went deaf. Return bool
from add() and free the packet back to the pool on failure.
This change addresses two issues. The first is that the
LilyGo_TLora_V2_1_1_6_terminal_chat build would try to compile
simple_repeater/MyMesh.cpp. All other examples of terminal chat
targets are instead building simple_secure_chat/main.cpp . This
change would align this build to the rest of the builds.
The second issue, found during the course of investigating the
first, stems from simple_repeater/MyMesh.cpp using the
MAX_NEIGHBOURS #define to control whether the neighbor list is kept.
Repeaters that keep this list must define this value, and if the
value is not defined, then all neighbor-related functionality is
compiled out. However, the code that replies to
REQ_TYPE_GET_NEIGHBOURS did not properly check for this #define,
and thus any target that compiles simple_repeater/MyMesh.cpp
without defining MAX_NEIGHBOURS would get an undefined variable
compilation error.
As a practical matter though, there are no targets that compile
simple_repeater/MyMesh.cpp AND do not define MAX_NEIGHBOURS,
except this build due to the first issue. As a result, the
second issue is addressed only as a matter of completeness. The
expected behavior with this change is that such a repeater would
send a valid reply indicating zero known neighbors.
Added support for 5-Way analog joystick.
Added Custom Sh1115 OLED driver.
Added NeoPixels support for Radiomaster Bandit.
Power output 20-30 dbm (100mW-1000mW).
Changed so Analog joystick can be used in UI.
Changed so NeoPixels is used for new Message. (Color can be defined).
Radiomaster Bandit Micro uses the same code as Nano.
Sensors connected via the Grove I2C connector (D18/D17) were not detected
because the firmware scanned the OLED I2C bus (Wire, D14/D15) by default.
Adding ENV_PIN_SDA/SCL flags directs EnvironmentSensorManager to use Wire1,
matching the physical Grove connector pinout.
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
