- Add #pragma once to SerialEthernetInterface.h
- Rename TCP_PORT to ETH_TCP_PORT with #ifndef guard
- Fix typos: "initalizing" → "initializing"
- Fix #elif without condition → #else for STM32 block
- Replace infinite loop on ETH init failure with halt()
- Remove heartbeat Serial.print(".") output
- Remove dead beginETH() call (ETH_ENABLED, not RAK_ETH_ENABLE)
- Comment out MESH_DEBUG and ETH_DEBUG_LOGGING build flags
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
Add W5100S Ethernet adapter support for RAK4631-based firmware, enabling
TCP CLI access on port 23 as an alternative to BLE/Serial connections.
- New SerialEthernetInterface for nRF52 with DHCP, reconnection handling,
and shared WB_IO2 power pin management with GPS module
- Ethernet build targets for repeater, room server, and companion firmware
- Prevent GPS from toggling WB_IO2 when Ethernet module is active
- CI build check for all three ETH firmware targets
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
Added NRF52840 power management core functionality:
- Boot‑voltage lockout
- Initial support for shutdown/reset reason storage and capture (via RESETREAS/GPREGRET2)
- LPCOMP wake (for voltage-driven shutdowns)
- VBUS wake (for voltage-driven shutdowns)
- Per-board shutdown handler for board-specific tasks
- Exposed CLI queries for power‑management status in CommonCLI.cpp
- Added documentation in docs/nrf52_power_management.md.
- Enabled power management support in Xiao nRF52840, RAK4631, Heltec T114 boards
The RAK4631/RAK4630 module are able to use the DC/DC converter. Enable
it to reduce power consumption.
Signed-off-by: Frieder Schrempf <frieder@fris.de>
The startOTAUpdate() is the same for all NRF52 boards. Use a common
implementation for all boards that currently have a specific
implementation.
The following boards currently have an empty startOTAUpdate() for
whatever reasons and therefore are not inheriting NRF52BoardOTA to
keep the same state: Nano G2 Ultra, Seeed SenseCAP T1000-E,
Wio WM1110.
Signed-off-by: Frieder Schrempf <frieder@fris.de>
Use a common begin() method that can be called from derived classes
to contain the shared initialization code.
Signed-off-by: Frieder Schrempf <frieder@fris.de>
