Drive WB_IO2 (slot power switch) HIGH via early constructor before the
Arduino framework initializes. Without this, the board brownouts on
POE-only power because the slot MOSFET isn't enabled early enough for
the RAK13800 POE module to deliver power to the baseboard.
Also remove the W5100S hardware reset pulse from Ethernet init — the
chip comes out of power-on reset cleanly, and toggling reset kills
the PHY link which breaks POE power delivery.
- Add #pragma once to SerialEthernetInterface.h
- Rename TCP_PORT to ETH_TCP_PORT with #ifndef guard
- Fix typos: "initalizing" → "initializing"
- Fix #elif without condition → #else for STM32 block
- Replace infinite loop on ETH init failure with halt()
- Remove heartbeat Serial.print(".") output
- Remove dead beginETH() call (ETH_ENABLED, not RAK_ETH_ENABLE)
- Comment out MESH_DEBUG and ETH_DEBUG_LOGGING build flags
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
Add W5100S Ethernet adapter support for RAK4631-based firmware, enabling
TCP CLI access on port 23 as an alternative to BLE/Serial connections.
- New SerialEthernetInterface for nRF52 with DHCP, reconnection handling,
and shared WB_IO2 power pin management with GPS module
- Ethernet build targets for repeater, room server, and companion firmware
- Prevent GPS from toggling WB_IO2 when Ethernet module is active
- CI build check for all three ETH firmware targets
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
Added NRF52840 power management core functionality:
- Boot‑voltage lockout
- Initial support for shutdown/reset reason storage and capture (via RESETREAS/GPREGRET2)
- LPCOMP wake (for voltage-driven shutdowns)
- VBUS wake (for voltage-driven shutdowns)
- Per-board shutdown handler for board-specific tasks
- Exposed CLI queries for power‑management status in CommonCLI.cpp
- Added documentation in docs/nrf52_power_management.md.
- Enabled power management support in Xiao nRF52840, RAK4631, Heltec T114 boards
The RAK4631/RAK4630 module are able to use the DC/DC converter. Enable
it to reduce power consumption.
Signed-off-by: Frieder Schrempf <frieder@fris.de>
The startOTAUpdate() is the same for all NRF52 boards. Use a common
implementation for all boards that currently have a specific
implementation.
The following boards currently have an empty startOTAUpdate() for
whatever reasons and therefore are not inheriting NRF52BoardOTA to
keep the same state: Nano G2 Ultra, Seeed SenseCAP T1000-E,
Wio WM1110.
Signed-off-by: Frieder Schrempf <frieder@fris.de>
Use a common begin() method that can be called from derived classes
to contain the shared initialization code.
Signed-off-by: Frieder Schrempf <frieder@fris.de>
