diff --git a/Setting-up-OpenWebRX-on-a-Raspberry-Pi-2.md b/Setting-up-OpenWebRX-on-a-Raspberry-Pi-2.md
new file mode 100644
index 0000000..0173456
--- /dev/null
+++ b/Setting-up-OpenWebRX-on-a-Raspberry-Pi-2.md
@@ -0,0 +1,21 @@
+OpenWebRX should work out-of-the-box on your RPi, if you set it up by [going through this guide](http://ha5kfu.sch.bme.hu/openwebrx-quick-setup).
+
+On this page I list some common errors that people have encountered:
+
+## Some general advice to increase reliability and security
+
+### Avoid possible file system corruption on poweroff
+
+If you just pull the plug from your Raspberry without properly shutting it down, it may or may not boot the next time. 
+
+#### 1. Shutdown the RPi with `halt` every time
+
+Use the proper command to halt the operating system:
+
+    sudo halt
+
+You will see one of the LEDs blinking at a given time interval, and then both LEDs switch off.
+
+#### 3. Start your system in read-only mode, and switch to read-write only if required.
+
+In my article about [pi-rw](http://ha5kfu.sch.bme.hu/node/160) you will find advice on doing that.
\ No newline at end of file